[Sensor input connection]
Connect one line of each sensor(infrared, heat, magnetic) to the number of sensor and the other line to ‘common’. (For sensor input, “NC, NO”. For type set-up, Environment set up -> “DIO”, select “LOW, HIGH”.)
For power supply for sensor, use a transformer.
[Alarm output connection]
The power should be lower than 12V, 300mA. When you use apparatus driven by AC power like an electric lamp, use a separate relay. Not in operation, the condition of connection is “NO”, when a control output is in operation, the output connection is Close(Short).
DVR program –> Environment set-up –> sensor/alarm -> select a camera to be connected to sensor.
When the sensor is activated, the alarm goes on for a set duration and the camera moves to preset position.
|
